Four Car Modifications That Have No Impact on Your Car’s Performance

“NOT CREATED EQUALLY”

by Contributor

Mysticsartdesign, Pixabay, License

(Apr. 27, 2020) — Car modifications have always been a part of the automobile culture. If you asked car owners, most of them would admit to wanting some kind of improvement on their vehicle. However, only a select group of people actually take the step forward towards modifying their vehicle to taste.

With the right kind of modifications, you can make a car a different kind of beast than it was during purchase. That kind of performance improvement, however, is only based on one’s knowledge of what works and what doesn’t.

While no car mod is bad in itself and may have some advantage, a number of them do very little for car performance. If you’re a performance-oriented car modifier, you may have to stay away from the following car mods:

Performance Spark Plugs

Spark plugs are one of the common car modifications where the performance version flatters to deceive. When most people look at performance spark plugs, they imagine that the multiple prongs mean that they produce better sparks. Unfortunately, it’s far from reality. While the multiple tips are not just a design gimmick, they have no better effect on performance than a single pronged plug would have. Performance plugs produce just the same voltage and spark as regular spark plugs.

Performance plugs do have the advantage of sparking across multiple points of the electrode and reducing wear and tear of the plug. This can lead to a longer plug life and, in a sense, better performance in the long run. However, it is important to note that in the immediacy, you won’t be getting any boost to your car’s horsepower by spending a couple of extra hundred bucks on a performance spark plug.

A Test Pipe

If you love the sound of a loud-sounding exhaust, then a test pipe can meet a need for you. Sound aside, a test pipe has no significant advantage for performance, not to mention that they are illegal in most states.

A test pipe is essentially a straight pipe you insert into your exhaust system to replace your catalytic converter. If you’re conversant with the exhaust system of cars, you’ll know that the catalytic converter is used to reduce emissions and noise pollution.

Test pipes are typically used by auto-mechanics to measure the amount of exhaust gas produced. It is used to test the efficiency of a catalytic converter. However, with modern electronically controlled car modules that can automatically detect faults, the need for it is greatly reduced.

Some people may, however, favor it for the sound it produces. If you’re one of those people, even if it is legal in your state, be prepared to deal with complaints of noise pollution from your neighbors.

Using Race Fuel

When people think of octane ratings, they think of cleaner fuel for higher performance. Well, that conception is only partially true. While higher octane fuels have better anti-knock properties, they do not do much for engine performance.

Car engines are typically produced with the recommended type of fuel in mind. In most cases, you will find the rating of fuel suitable for your car on the owner’s manual. The common rating for streetcars is 87 octane.

Regular car engines usually have a fixed compression ratio of between 8:1 to 11:1, which determines how well they compress and burn fuel. Sports cars, on the other hand, have compression ratios from 14:1 upwards. If your engine doesn’t have enough compression to burn high octane fuel, your car is likely to run slower than you intended it to.

In a best-case scenario, using race fuel will cost you more money without increasing performance. In a worst-case scenario, you end up losing both money and performance. Short Ram-Air Intake

Typically considered as an alternative to cold-air intake systems for people looking to reduce air circulation to their car’s engine, short ram-air intake systems tend to underwhelm when it comes to performance. While the short ram air intake has an impact on the car’s performance, it is not nearly as productive as it’s cold air companion.

They are marketed as providing a shorter route for air going to the engine than a cold-air intake, which they do. In the case of a short ram, it takes in air from the engine bay back into the engine. While this is typically a short process enhanced by straight, smooth piping, it can cause a few problems. The air in the engine bay is usually warm; when drawn into the engine through the intake, it may not have any significant effect on the engine’s performance.

For a short-ram system to work at maximum efficiency, the driver will have to be at high speed, which you will not be able to do most times. Short-ram intakes do have the advantage of being aesthetically pleasing.

Adjustable Preload Springs

The problem with suspension upgrades is that suspension systems are very complicated. Springs are a part of the suspension system, and replacing them should be done with utmost care. Springs work both in compression and extension. Having too much preload can make your spring soft on compression, and this can lead to harshness.

Springs should not be tampered with unless you’re skilled enough to know the implications on your suspension system. Contrary to popular opinion, stiffer springs do not improve handling as most cars already come with a linear-rate spring. Even though it sounds and looks cool, having adjustable preload springs can cause more problems than you can handle.

Conclusion

As have seen so far, car mods are not created equally. This is not to these modifications are not useful. Some people might prefer certain mods for their aesthetic value and that’s okay. These 5 mods, however, either have equally effective and cheaper alternatives or better, similarly-priced alternatives.

However, for people looking to make performance-oriented mods you should reach out to licensed dealers who can give you accurate information. For Ford users that need to make modifications, you can get more info here.